Restomod Racing

Since the clutch peddle engaged close to the floor, Shane decided to check the clutch peddle higth

and free play.  His clutch peddle is 5.5″ from the floor.  The factory calls for 6.18″ to 6.57″, so adjusting is in order.  In order to get to the adjusting rod, he needed to remove the lower dash cover.  Once removed he had good access to the clutch peddle.  He first turned the clutch peddle stop out, but to his surprise the peddle did not move.  He realized that the clutch master cylinder rod was holding it from moving.  He loosened the lock nut and removed the pin from the bolt that holds the master cylinder rod to the clutch peddle.  He turned it out until he could obtain the 6.5″ peddle higth.  Now he needed to adust the free play.  This is achieved by turning the peddle higth adjuster until he has a little less than 1/2″ of free play.  Once this is achieved he tightened the lock nut.